Next Steps

-T3 support
-Zodiac Support
-iQue support
-SDIO support



Beta 1.0.9 was jsut released. This adds official T|C support and full read-write MMCplus support. Now MMCplus cards read, write, and on devices like TX, LD, T5, and Zire 72 are 3 - 5 times faster than they were with Palm's driver (on E2, Z31, and TC it is just 1.5 - 2 times faster). See previous blog entry to speed results.

Also fixed is a small UI bug where PowerSDHC splash screen left the DIA on 320x480 devices in an indeterminate state.



Version 1.0.9 beta is being internally tested. It finally adds full support for MMCplus memory cards at fill speed and 4-bit mode. This means that new MMC cards are much faster? How much? Here is a comparison of the same card with original and my driver.


Beta 1.0.5

Beta 1.0.5 has been released which starts after reset, and in general is more polished and nice.


Beta 1.0.2

PalmSDHC beta 1.0.2 has been released. It features bug fixes (enabling driver while no card inserted on TX and T5 now works well) as well as partition support (primary only - not extended). The app itself will not partition the card for you - that is up to you, but if you insert a partitioned card, it will gladly support up to four partitions. Download is on www.PalmPowerups.com and all users whose trial with previous beta has run out can now get a new trial key to try this beta too.